6 Comments

Make your own M80 firecracker?

I’m not going to go into much detail concerning the following tutorial. It’s out there for those that may be interested. Please check your local laws concerning the use of explosive materials such as fireworks.

i-Hacked has a very watered down tutorial on the steps necessary to create your own homebrew 4th of July M80 firecrackers.

UNEASYsilence does not condone or support the creation of explosive items. Use and destroy at your own discretion.


  • http://fernyb.net FernyB

    You can also buy fireworks and remove the power from them and dump it in a two little bottle and insert the match at the cap then light the sucker and kaboom!

  • http://www.liveemporium.com live emporium

    Useful information – In 1976, federal regulations were passed to limit all consumer-grade fireworks in the United States to a maximum of 50 milligrams black powder. 200 milligrams was once the legal limit of pyrotechnic composition but today it is 50 milligrams.

    What you can do is take off the cap and add about 20mg more powder to your shell and bam, have you got one highly explosive illegal firecracker on your hands.

    Once again I would never condone such behaviour.

  • Pyro

    take 1 “Piccolo Petes” fountain
    empty contents into plastic bottle
    poke a hole in the cap (for the fuse)
    tilt upside down (so contents make contact with the fuse)
    turn on side and light (contents should keep some contact with fuse)
    RUN AWAY!
    *BOOM*

    DISCLAIMER:
    **********I do not suggest doing this, unless the Local law permits it. I will not take responsibility for your actions. This information is purely ment to be informational. Use this knowledge at your own risk!**********

  • http://pol.net nick

    Take 3 grams of fine mesh aluminum powder, 7 grams of potassium perchlorate, as well as some firework shells and fuses. Sift and mix the powders, pour 3 grams of it into a 3/4 inch thick paper tube.

  • stefan flores

    i dont know what this would compare to but it is extremely powerful.

    requirements needed:

    1 Pilot ball point pen, some black powder, and a fuse, i just take my fuses off bottle rockets.

    steps:

    1. unscrew the pen. remove the ink thing. pour black powder in each part of pen, and screw back together.
    2. the tip of the pen that you write with, you put the fuse in that hole, and make sure it is touching the blackpowder.
    3. Light and RUN. i have blown up many stuff with this

  • jack

    get the powder out of one packet of caps and put it into a .22 magnum empty case push it downwith a pen ink not too hard or it will go off put in a fuse a sparkler works light it and run ******disclaimer*******
    these are small but very dangerous they throw out little razor shap pieces of bullet every where im not responsible for what you or your idiot friends do with these!

Privacy Policy | About Us | Contact Us | Write for us